Micro One 150 Kit, made of R150 mod and Minos tank, realizes comprehensively upgrading on the base of Micro One. You will love it at the first sight. Its compact size is pocket friendly and portable; three selective shell colors with paint finish show your style. The max output power can up to 150W of R150; Minos is one special sub-ohm tank which could change to RTA easily just with the super large deck M2. The cost effective and affordable, upgrading experience of Micro One 150 Kit lets you enjoy vaping anytime and anywhere.
Bottom airflow system
There are two adjustable air slots evenly spaced on the bottom, airflow can be adjusted freely, which allows you to have an extremely open draw.
Deck & core
M2 deck: Dual core,24.5mm big build deck,0.3ohm Q2 core,Fe-Cr and nickel-chromium material
Minos Q2 core: Lower wattage & more vapor,sweet like a cotton candy,0.3ohm(30-80W)
510 RDA drip tip for totally new experience
The 510 RDA drip tip with the V shape airflow channel will definitely create a totally different vaping experience that most people shall like. And its cone-like body looks pretty cool!
TOP refill system,filling in one go
Minos uses top refill system with hinge lock, you just need to swivel its top cap, and then fill easily. And the leak proof e-liquid slot can significantly solve leaking problem
HOW TO BUILD THE RTA (M2)
1.Before starting make sure your hands are clean.
2.Taking the Minos-RTA M2 deck apart.
3.Installing the pre-wrapped coil.Insert one end of your coil into the up-side screw, and the other end into the down-side screw.
4.Positioning and cutting the exceeding ends of wire offMake sure the coil is fixed and lined up with the air hole, and also make sure the coil is NOT touching the deck. Then cut the exceeding ends of wire off.
5.Cutting a strip of cotton and make sure it's just larger than the coil you built.
6.Inserting the cotton, and placing it in the middle.
7.Cutting the wick at an angle and make sure it's not too short and not too long.
8.Wet the coil with your e-liquid and adjust the wick.
Warning: Coils must be checked for resistance before they are fired on a device, and re-checked periodically to ensure the resistance remains the same.
R150 TC box mod:
Adjustable initial resistance
As temperature sensing coils tend to be sub-ohm, the poor contact problem can make a big error, in a way that is not evident when an atomizer is being used for wattage control only. This function is designed to ensure your resistance on the load remains the same. And its adjustable range is ±50 mΩ (± 0.05Ω).
SS/NI200/TI wire support
R150 TC can support temperature control with Stainless Steel wire as well as Nickel 200 & Titanium, and allow you to adjust their TCR (Temperature Coefficient of Resistance) in different ranges for further improving the accuracy of temperature control and bring you the best taste.
Spring-loaded center pin
Clicky and smooth buttons
Easy-to-read Oled display show output wattage,output voltage,atomizer resistance and remaining battery life,etc.
Micro-USB port for charging and upgrade
Intelligent atomizer recognition
Puff monitoring system
12 seconds cut-off
Short circuit protection