Side airflow slots direct-to-coil design, you can enjoy a strong and open draw like RDA!
Deck & base two in one structure,more juice capacity
Super big replaceable deck with 16mm in diameter, so easy to build
TF-RDTA S2 Deck
Dual post velocity style
16mm big build deck
0.2ohm dual claption wire(pre-installed)
Hidden sealing ring and innovative juice flow control system can significantly solve the leaking problem
Patented swivel-cap design makes top-filling as easy as it gets
Double-layered drip tip(inner tube of glass,outer tube of stainless steel)
HOW TO BUILD THE TF-RDTA S2 DECK
1 .Before starting make sure your hands are clean.
2.Taking the TF-RDTA S2 deck apart.
3.Installing the pre-wrapped coil.
Insert one end of your coil into the left-side holes, and the other end into the right-side holes.
4.Positioning and cutting the exceeding ends of wire off. Make sure the coil is fixed and lined up with the air hole, and also make sure the coil is NOT touching the deck. Then cut the exceeding ends of wire off.
5.Cutting a strip of cotton and make sure it’s just larger than the coil you built.
6.Inserting the cotton, and placing it in the middle.
7.Then guide the ends of cotton wick through the holes below.
8.Cutting the ends and make sure it’s not too short and not too long.
9.Wet the coil with your e-liquid and adjust the wick.
Warning: Coils must be checked for resistance before they are fired on a device, and re-checked periodically to ensure the resistance remains the same